YOKOGAWA CW140, User Manual, Page: 126 / 292

IM CW140-E
12-6
12.4 Logging in Harmonics Measure Mode
Using the logging function, you can continuously take measurements and
save data. (To save data, set "LOGGING" to ON and select the output
destination, or use the file function.)
●
Procedure for Starting Logging
(TIME): Enters the starting time (default is the current time).
(TRIGGER) - Control: Allows you to control logging by inputting a
signal to the START/STOP input terminals.
(MANUAL): Allows you to start logging by pressing the key.
The default for this key is "Manual".
●
Procedure for Stopping Logging
(TIME): Enters the ending time.
(TIMER): Enters the time taken from the start to the end of
logging.
(TRIGGER) - Control: Allows you to control logging by inputting a
signal to the START/STOP input terminals.
(MANUAL): Allows you to stop logging by pressing the key.
The default for this key is "Manual".
Setting the time:
Use the key to move through the fields of the date and time setting, as
shown below.
2000 / 01 / 01 / hour : minute
Year ↔ Month ↔ Day ↔ Hour ↔ Minute
(+): Increment
(–): Decrement
Input a value.
Setting the time:
Use the key to move through the fields of the time setting, as shown
below.
0000 h / 00 m/ 00 s
Hour (and no. of digits) ↔ Minute ↔ Second
(+): Increment
(–): Decrement
Input a value.
You can set the interval from the starting to the ending time, in 10-second
increments, to a maximum of 1000 hours.
Holding down the (+) or (–) key during input of a value,
increases the speed with which the value changes.