Xerox ColorQube 9201, System Administrator Manual

Page: 77 / 336

Network Installation
Xerox ColorQube™ 9201/9202/9203
System Administrator Guide
69
2. Click on the [Properties] tab.
3. If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111] .
4. Click on the [Login] button.
5. Click on the [Connectivity] link.
6. Click on the [Protocols] link.
7. Select [IP (Internet Protocol)] in the directory tree.
8. Ensure that [IPv6] is selected.
9. In the General area:
a. Check the [Enabled] checkbox for Protocol to enable the TCP/IP protocol.
Note: If you do not check the [Enabled] checkbox for Protocol, you will not be able to access
Internet Services. TCP/IP must then be enabled from the device's user interface.
Note: If you uncheck the [Enabled] checkbox for [Protocol] , the Network Controller will reboot.
This may require several minutes, during which time all network services will be unavailable.
b. Enter a name which corresponds to the IP address of the device in the [Host Name] field.
c. [Physical Connection] will display the physical network connection. This will display
“Ethernet” .
d. Enter details of an identifier of the IP site in which the device is connected in the [Domain
Name] field.
10. In the Stateless Addresses area:
a. The Link-Local Address is automatically populated.
This is a network address which is intended only for use in a local data link layer network, and
not routed beyond that network. Link-local addresses are often used for network address
auto-configuration where no external source of network addressing information is available.
The printer's IPv6 Link-local address is automatically generated, and displayed here. Link-
local addresses always begin with
“fe80” .
b. Check the [Use Router Supplied Prefixes] checkbox if router advertisements are used.
A router-supplied prefix is the 64-bit (sub-) network address. If routers are present, they will
periodically send Router Advertisement packets containing address prefixes. These prefixes
determine what sort of auto configuration can be done by the device. Select this setting to
use Router Supplied Prefixes. When enabled, Global Addresses associated with this device are
displayed. If there are no routers on the network, this setting can be disabled.
c. The [Global Addresses] will display any global addresses associated with the device. Global
addresses are equivalent to public IPv4 addresses. They are globally routable and reachable
on the IPv6 internet.
11. The device performs auto-address DHCP configuration every time it powers up. This is used for
neighbour discovery and address resolution on the local IPv6 subnet.
However, you can choose to use manual configuration, automatic configuration or a combination
of automatic and manual configuration.
Default Dynamic Host Configuration Protocol (DHCP) Settings area:
a. Select one of the following options:
• Use DHCP as directed by a router - this option is fully automatic. The DHCPv6 Address
will be obtained and displayed on the screen.