IP Filter Configuration
Version 1.0 Rev B - 08/00
29
IP Filter Configuration
You can define IP address filters to control the data that is transmitted and received
through the Hopper Plus unit. The following table describes the IP filters.
Each IP address list is defined by a range and base value. The range defines how many
contiguous IP addresses are in the list, and the base sets the lowest address of the list.
The following is a list of addresses and their capabilities:
Filter
Setting
IP packet
off (disabled)
All packets are passed.
on (enabled)
Only IP and ARP packets are passed.
IP address
off (disabled)
All IP packets are passed.
on (enabled)
Only packets whose IP addresses reside in at least
one of the IP filter lists are passed. There are five IP
filter lists: each can contain up to 255 IP addresses.
Addresses that pass only IP
packets and IP Addresses
192.168.2.10
192.168.2.11
192.168.2.11
192.168.2.12
192.168.2.13
194.120.3.51
194.120.3.52
194.120.3.254
194.120.3.255
194.120.4.0
194.120.4.1
Configure IP Filtering as:
IP Packet Filtering = on
IP Address Filtering = on
Filter 1 Range (0 - 255) = 4
Filter 1 Base Address = 192.168.2.10
Filter 2 Range (0 - 255) = 2
Filter 2 Base Address = 194.120.3.51
Filter 3 Range (0 - 255) = 4
Filter 3 Base Address =
194.120.3.254
