Water I.D. Primelab 2.0, Manual

Page: 160 / 301

(30) Iron HR
(total)
0.0 - 30.0 mg/l (Fe²⁺/Fe³⁺)
Liquid
Internal Name: 30-Iron-HR-liq
10ml
65ml PL Iron HR N°1
(PL65IronHR1)
PL Iron HR 2 (PL65IronHR2)
Measurement procedure:
1 Fill 10 ml unfiltered sample water into a clean 24 mm cuvette.
2 Screw the lid back on the cuvette.
3 Insert the cuvette into the PrimeLab. Pay attention to the arrow on the front of the cuvette.
4 Start ZERO measurement.
5 Remove the cuvette again.
6 Unscrew the lid from the cuvette.
7 Add 2 drop(s) of PL Iron HR 2 into the cuvette.
8 Screw the lid back on the cuvette.
9 Gently swirl the cuvette to mix the liquid well.
10 Insert the cuvette into the PrimeLab. Pay attention to the arrow on the front of the cuvette.
11 Tap TEST to perform the measurement.
12 Wait until the 02:00 minute(s) countdown ran out.
13 Remove the cuvette again.
14 Unscrew the lid from the cuvette.
15 Add 15 drop(s) of PL Iron HR 1 into the cuvette.
16 Screw the lid back on the cuvette.
17 Gently swirl the cuvette to mix the liquid well.
18 Insert the cuvette into the PrimeLab. Pay attention to the arrow on the front of the cuvette.
19 Tap TEST to start a 05:00 minute(s) countdown.
20 After the lapse of a 05:00 minute(s) countdown the measured value is displayed.
Notes:
Special accessories required / not included as standard equipment!
If the sample contains undissolved iron, filter thoroughly (several times, if necessary).
T105/204 T105/204