Water I.D. Primelab 2.0, Manual

Page: 149 / 301

(173)
Sanosil Super25 Ag
0 - 400 mg/l (Sanosil)
Liquid
Internal Name: 173-Sanosil-liq
10ml
65ml PL Hydrogen Peroxide HR N°1
(PL65HydHRP1)
65ml PL Hydrogen Peroxide HR N°2
(PL65HydHRP2)
Measurement procedure:
1 Fill 10 ml test water into a clean 24 mm cuvette.
2 Screw the lid back on the cuvette.
3 Insert the cuvette into the PrimeLab. Pay attention to the arrow on the front of the cuvette.
4 Start ZERO measurement.
5 Remove the cuvette again.
6 Unscrew the lid from the cuvette.
7 Add 3 drop(s) of PL Hydrogen Peroxide HR 1 into the cuvette.
8 Gently swirl the cuvette to mix the liquid well.
9 Add 3 drop(s) of PL Hydrogen Peroxide HR 2 into the cuvette.
10 Screw the lid back on the cuvette.
11 Gently swirl the cuvette to mix the liquid well.
12 Insert the cuvette into the PrimeLab. Pay attention to the arrow on the front of the cuvette.
13 Tap TEST to perform the measurement.
14 The measured value is immediately displayed.
Notes:
All oxidizing substances in the water sample, such as chlorine, active oxygen, bromine, will also
be detected and contribute to the result.
T94/204 T94/204