SECTION 5 – INSTALLATION ANd prOgrAmmINg
PAGE 5-32 REV. 0 2014-MAY-02
CHECKFIRE 210
Detection and Actuation System
TABLE 5-5: pErSONAL COmpUTEr (pC) OpTIONS
personal Computer (pC) programming
Authorized ANSUL Distributors with CHECKFIRE 210
System contracts have access to the ANSUL CHECKFIRE
210 Programmer software. The same programming options
described in the previous table for the ICM have matching
programming in the PC software.
Install the latest version of the ANSUL CHECKFIRE 210
Programmer utility software on a PC to read and write infor-
mation to the ICM.
Note: It is not necessary to install a battery module or provide
external power to the CHECKFIRE 210 ICM when using the
PC interface. The PC provides power for system operation
through the USB communication cable.
Connecting the ICm to a pC
Establish communication between the ICM and a PC using
the mini USB serial port under the ICM battery compartment
cover.
1) Loosen the (4) captive screws and remove cover to gain
access to the programming button.
2) Connect an appropriate USB Communication Cable*
between the mini B USB port on the CHECKFIRE 210
ICM and a Standard A USB port on your PC.
* Interface Cable: USB A Male plug and Mini B
plug x 10 ft (3 m) long.
3) Launch the CHECKFIRE 210 Programmer application
software on the PC.
4) Select the appropriate COMM port from the drop down
list at the top left of the application window then click
Connect.
Note: PC programming should be performed at or near
normal temperature conditions. Corrupted or incomplete data
can occur if programming is attempted at extreme high or low
temperatures.
009279
MINI USB
PORT
INSTALL
CABLE TO
CONNECT
wITH PC
009327
SELECT PORT
AND CLICK
CONNECT
009326
PSF-1
DET-2
DET-3
DET-4
TD1-5
TD1-6
TD2-7
TD2-8
TDR-9
RLY-10
RLY-11
ICM PROGRAMMING
LED IDENTIFIERS
SAME PROGRAMMING OPTIONS AS THE ICM
PROGRAMMING BUTTON AND LEDS
