SECTION 5 – INSTALLATION ANd prOgrAmmINg
PAGE 5-2 REV. 0 2014-MAY-02
Surface mounting Instructions (Continued)
8. Hand-tighten enclosure nut on threaded boss, see Figure
5-3.
NOTICE
Only hand-tighten enclosure nut, do not
use mechanical force such as a wrench.
FIgUrE 5-3
SUrFACE mOUNT 210 dISpLAY mOdULE
009304/009305/009306
Bracket mounting Instructions
Bracket mounting requires the CHECKFIRE 110/210 Mount-
ing Bracket (Part No. 439564). The bracket is a two piece,
multi-position bracket for securing the display module in a
variety of configurations. Mount on a flat surface that will prop-
erly support the display module during all vehicle/equipment
operating and environmental conditions (e.g. shock and vibra-
tion).
The bracket includes a Bracket Base, a Swivel Mount and
two swivel joint screws, see Figure 5-4. The display module
attaches to swivel mount in a horizontal or vertical position on
either side of swivel mount.
FIgUrE 5-4
CHECKFIrE 110/210 mOUNTINg BrACKET
009181
1. Refer to layout drawing for planned location and determine
a position within the operator’s reach with the best viewing
angle for display module LEDs and easy access to display
module buttons. Verify the location meets approval of the
vehicle/equipment owner and/or vehicle/equipment service
manager. See Figure 5-5 for sample mounting options.
Note the positions of swivel mount and connectors.
CHECKFIRE 210
Detection and Actuation System
FORwARD AND
BACK CONNECTORS
(FOUR PLACES)
SwIVEL jOINT
SCREw (TwO
PLACES)
BRACKET BASE
SwIVEL
MOUNT
INDEx HOLE
(FOUR PLACES)
HAND-TIGHTEN
ENCLOSURE NUT
INDEx HOLES
(TwO PLACES)
RUBBER
wASHER
MAxIMUM 3/16 IN.
(4.7 mm) THICKNESS
FOAM GASKET
