SECTION 5 – INSTALLATION ANd prOgrAmmINg
2014-MAY-02 REV. 0 PAGE 5-3
Bracket mounting Instructions (Continued)
FIgUrE 5-5
SAmpLE mOUNTINg OpTIONS
009307/009308/009309
2. Confirm access to the display module for proper cable
connections, periodic inspections, and maintenance. Verify
module location and connections will not interfere with
vehicle/equipment operation, service, and maintenance.
3. Using the bracket base as a template (see Figure 5-6),
mark and drill 9/32 in. (7 mm) holes in the flat surface
(4 places).
4. If needed, mark a 1 5/8 in. (42 mm) dia. circle in the
mounting surface, matching center of the 7/8 in. x 1 3/4 in.
(22 mm x 44 mm) opening for cables passing through the
mounting surface. See Figure 5-6. Drill the marked hole.
Remove burrs and sharp edges; protect cables as needed.
FIgUrE 5-6
BrACKET BASE FrONT VIEW
009113
5. Secure base to mounting surface using appropriate length
fasteners (1/4 in. (6 mm) screws or bolts with lock washers
and nuts).
6. Attach display module to swivel mount according to the
position determined in Step 1.
a. Retrieve enclosure nut and rubber washer for threaded
boss from separate bag in the CHECKFIRE 210 Ship-
ping Assembly (Part No. 439559).
b. Carefully feed cables through center hole in Swivel
Mount, rubber washer, and enclosure nut.
c. Insert index pins into index holes and hand-tighten
enclosure nut to threaded boss. See Figure 5-7.
CHECKFIRE 210
Detection and Actuation System
009113
TwO SwIVEL jOINT
CONNECTORS ON
EACH SIDE
OPENING
FOR CABLES
9/32 IN.
(7 mm) HOLES
(4 PLACES)
3 1/2 IN.
(89 mm)
4 3/4 IN.
(121 mm)
1 3/4 IN.
(44 mm)
2 9/16 IN.
(65 mm)
1 1/2 IN.
(38 mm)
7/8 IN.
(22 mm)
FULL ExTENSION
VERTICAL BASE, CONTROL
MODULE AT 90 DEGREES
ExTENDED SwIVEL MOUNT
IN BACK CONNECTORS
VERTICAL BASE, INSET
SwIVEL MOUNT
INSET SwIVEL MOUNT
ANGLED BASE
