Tsino Dynatron CoolDrive Series, User Manual, Page: 6 / 285

Safety Instructions
5

Installation precautions:
Note

Install the servo drive in a position with sufficient bearing capacity according to the technical data.

Install the servo drive, servo motor, regenerative resistor and dynamic brake resistor on non-combustible
items.
Installing directly on or near combustible items may cause a fire.

When installing the product, make sure that specified distance is maintained between the servo drive and the
inner surface of the control cabinet and other machines .
Failure to do so may result in fire or malfunction.

Install the servo drive in the prescribed direction.
Failure to do so may result in fire or malfunction.

Do not step on this product or place heavy objects on it.
Otherwise it could result in malfunction, damages, or injury.

Prevent foreign objects from entering the servo drive.
It may cause a malfunction or fire.

Keep and install the product in places:
• Without direct sunlight
• Where the ambient temperature does not exceed the limits allowed for running this product
• Where the relative humidity does not exceed the limits allowed for running this product
• Where condensation does not occur due to rapid temperature changes
• Where there is no corrosive gas or flammable gas
• Without combustibles
• With less dust, salt and metal powder
• Free of splashing of water, oil and liquid medicine
• Where vibration or impact does not affect the product (the level of vibration or impact does not exceed the
limits allowed for running this product)
• That are not exposed to radiation
Keeping or installing this product in an environment other than the above may cause product failure or
damages.

Use this product in required conditions of its specifications.
Using this product in an environment that does not satisfy the conditions in its specifications may cause product
failure or damages.

Servo drives are precise equipment. Do not drop it or apply any strong impact on it.
This may cause its malfunction or damage.

The servo drive must be installed in the control cabinet.

Do not block the air inlet and air outlet of this product, and do not allow foreign objects to enter the inside of
this product.
Otherwise, this product might malfunction.