Trumpf BendMaster 150, Operator'S Manual

Page: 94 / 258

5. Options at the TruBend
The following TruBend options must be available if work on the
TruBend is to be automated with a BendMaster:
■ CNC-crowning.
■ Hydraulic tool clamping.
■ BendMaster interface.
■ Sensor gauge finger.
No optoelectronic protective devices are required for manual
press brake bending if the BendMaster is used on the TruBend.
It is sufficient to use operating station 1 in two-hand operating
mode.
The BendMaster must be in home position when operating the
bending cell manually. All doors must be closed. The operator is
locked in within the safety fencing.
Some of the options of the TruBend must not be available when
using the BendMaster. These are:
■ Bending aid.
■ Additional backgauge finger.
■ Upholding device.
■ Light curtain.
■ Second operating station.
The following modules must be removed from the TruBend
before using the BendMaster:
■ BendGuard.
■ Support brackets.
3
‐
30
Options at the TruBend 2015-06-01
B579EN
TRUMPF BendGuard
Unavailable options in
combination with
BendMaster