Trumpf BendMaster 150, Operator'S Manual

Page: 179 / 258

Selecting a separation method
1. In the "Tooling plan" mask,Press Continue .
or
Ø press > Set up > Separation method .
Fig. 51856
2. Under "Tool for", select Robot or Regripping station (if pro-
grammed in TruTops).
3. Select "Gripper" for the previously selected tool.
Note
At present, only the gripper used in TruTops can be selected.
4. Set the suction and blow-off times:
− "Timeout suction":
Delay until the vacuum switch is actuated.
− "Blow-off time": period during which the sheet is blasted
when deposited.
− "Blowing clean time":
Period after depositing the blank during which blasting is
continued during the travel motion up to the next interpo-
lation point. This prevents the blank from moving within
the stack or sticking to the gripper. In addition, the vac-
uum system is cleaned.
5. Set "Holder location":
B579EN
2015-06-01 Running in a TruTops program
4
‐
85