Selecting operating modes
1
Zero position
2
TruBend manual
3
Key switchOPERATION
MODE SELECTION
4
Manual operation
5
Automatic mode
Fig. 46231
Ø
Set the OPERATING MODE key switch for operating mode
selection to the desired operating mode.
Enabling conditions for operation modes
All EMERGENCY STOPs released
:
■
At TruBend (control system and control panel).
■
On the portable manual control unit.
■
On the support for the portable manual control unit.
■
On all posts of the safety fencing.
TruBend
:
■
CONTROL key switch is set to ON.
■
Press beam not in sloping position.
■
Rear protective cover is closed.
BendMaster
:
■
Manual operating mode is active.
■
The ENABLE KEY of the portable manual control unit is
pressed in the neutral position.
Tip
To deactivate an activated catch, press the RED button on the
mounting device for the portable manual control unit.
B579EN
2015-06-01
Operating the BendMaster
4
‐
17
Enabling conditions for
manual mode
Summary of Contents for BendMaster 150
