Trumpf BendMaster 150, Operator'S Manual

Page: 177 / 258

Name Description
Job Name of the job in which the stack was created.
Range Specifies whether the stack is a loading or unload-
ing stack.
Stack use ■ Stacked = the blanks are picked up as program-
med in TruTops.
■ Box = the finished parts are placed in a box.
Number of layers Number of layers of the stack.
Current number of
sheets Number of finished parts in the unloading stack.
Can be changed by a piece with
Sheet , Increment
Sheet or Sheet , Decrement Sheet .
Quantity intermedi-
ate layers Number of intermediate layers in the unloading
stack.
Max. sheets Maximum number of finished parts which can be
deposited on the unloading stack until
A stack full
is established. The maximum number of finished
parts comes from TruTops and depends on the
simulated unloading stack. It can only be reduced,
not increased.
Details on the loading stack Tab. 4-21
14. Press Display , Overview to display the graphic again.
The stack processing sequence can be adjusted both for loading
and unloading stacks, e.g. when using eccentric grippers. This is
only possible with a loaded job:
Fig. 51855
15. Mark the desired stack under "Loading stack" or "Unloading
stack".
16. Move the marked stack up using ↑ or down using ↓.
The stack at the first position is executed first, the stack at
the second position is executed second, and so on.
B579EN
2015-06-01 Running in a TruTops program
4
‐
83
Redisplaying the diagram
Defining the stack
processing sequence