Trumpf BendMaster 150, Operator'S Manual

Page: 176 / 258

To reset the number of parts deposited on an unloading stack to
0 and switch the stack mode back to
A stack ready :
11. Press Process , Empty unloading area . The stack is emptied.
or
Ø Press Empty all unloading areas . All stacks are emptied.
The number of blanks in the loading stack or the number of fin-
ished parts in the unloading stack can be increased or reduced
by pressing the button once. This is only possible with a loaded
job.
12. Press Sheet , Increment Sheet .
or
Ø Press Sheets , Decrement Sheet .
Note
This change also has an effect on the blank loading or part
depositing process. Note that there is a risk of collision!
13. Press Display , Details .
The details on the selected stack are displayed and can be
edited. Grayed out fields cannot be edited.
Name Description
Job Name of the job in which the stack was created.
Range Specifies whether the stack is a loading or unload-
ing stack.
Stack use Stacked = the blanks are picked up as
programmed in TruTops.
Number of layers Number of layers of the stack.
Current number of
sheets Number of sheets of sheets in the loading stack.
Calculated on the basis of the stack height. Can be
changed by the thickness of a sheet with
Sheet ,
Increment Sheet or Sheet , Decrement Sheet .
Quantity intermedi-
ate layers Number of intermediate layers in the unloading
stack. Calculated on the basis of the stack height.
Can be changed by the thickness of an intermedi-
ate layer with
Sheet , Increment Sheet or Sheet ,
Decrement Sheet .
Offset fine recogni-
tion 1 Indication of the offset value when using height
compensation during the initial fine recognition proc-
ess.
Offset fine recogni-
tion 2 Indication of the offset value when using height
compensation during the second fine recognition
process.
Note The height compensation is carried out during
a third fine recognition process, even if the corre-
sponding offset value is not displayed.
Details on the loading stack Tab. 4-20
4
‐
82
Running in a TruTops program 2015-06-01
B579EN
Emptying an unloading
stack
Changing the number of
finished sheets
Displaying stack details