Trumpf BendMaster 150, Operator'S Manual

Page: 134 / 258

Referencing the Z, A, B, C, Z1, Z2 axes
Conditions
■ Manual operating mode is active.
■ No error messages, i.e. green LED on the portable manual
control unit lights up (acknowledge error if red LED is on).
(see "Enabling conditions for operation modes", pg. 4
‐
17) .
■ The BendMaster is ready for operation (pulse trigger switch
on the portable manual control unit has been pressed,
"BendMaster" icon is green).
1. Select the > Position > Position menu on the portable manual
control unit.
2. Press Reference .
The axes to be referenced appear in the right-hand side of
the monitor screen against a blue background.
Fig. 40856
3. Move the axes until the reference marks are in alignment
with each other.
4
‐
40
Switching on and referencing the BendMaster 2015-06-01
B579EN