Trumpf BendMaster 150, Operator'S Manual

Page: 37 / 258

operator must replace and put the safety devices into operation
after completing work.
Once per shift, preferably before starting the production:
■ Check the safety devices for proper function.
User:
■ The user must ensure that the machine is installed as per
the installation plan and installation conditions.
■ The user must ensure that only authorized personnel works
at the machine.
■ The operator must ensure that damaged or missing danger
signs on the machine are replaced.
■ The user or the persons appointed by him/her must operate
the machine when it is in perfect working order.
■ The user must ensure that the work station is kept clean and
tidy by issuing appropriate instructions and conducting
inspections.
■ The user must ensure that the working areas are supplied
with sufficient fresh air.
Operator:
■ The operator must immediately report changes (including the
operating performance) occurring in the machine to the oper-
ator. The machine must be checked for externally visible
defects and damage at least once per shift.
■ The machine must be checked for externally visible defects
and damage at least once per shift.
■ The operator must check the tooling status prior to operation
of the machine to avoid any risks due to an incorrect tooling
status.
■ Before starting the machine, the operator must always make
sure that nobody is within the danger zone.
The prescribed shutdown procedures must be adhered to during
all operations (e.g. setting and maintenance work).
5.4 Pay attention to water protection
Water-pollutant substances (e.g. oil) should not enter the ground
or into water bodies.
The principle of precaution is applicable for machines in the Fed-
eral Republic of Germany: water should not become contami-
nated when using water-pollutant substances (Federal Water Act
WHG).
B579EN
2015-06-01 Organizational measures to be taken by the user
1
‐
21
Ensuring the perfect
working order
Observing the shutdown
procedure
The Federal Republic of
Germany