Trumpf BendMaster 150, Operator'S Manual

Page: 118 / 258

Fig. 39947
3. Select the speed using the speed buttons V- or V+.
The speed window is at the top right of the screen. The cur-
rent speeds in manual and automatic mode are displayed
there.
Pressing the velocity button always changes the velocity which is
displayed in large black letters in the velocity window.
Possible speeds in manual mode:
■ Incremental between 0.1 I and 1.0 I
(1 I corresponds to 0.1 mm/degrees or 1 mm/degree,
depending on which move coordinate system is set).
■ 2% to 5% in steps of 1%.
■ 10% to 100% in steps of 5% (at continuous pressure in
steps of 5%, and then 10%).
Speed in automatic mode:
■ 0.1% and from 1% to 100% in steps of 1% (at continuous
pressure in steps of 5%, and then in steps of 10%).
4. With write permission: press the speed window as required.
Manual speed is switched to automatic speed or vice versa.
5. Use the traverse buttons to move in the displayed direction.
The BendMaster is moved in the displayed direction as long
as the traverse button is pressed.
There are six traverse coordinate systems available to move the
axes. Four of them can also be used to display the axis posi-
tions on the screen (= displayed coordinate system):
■ Axis coordinate system ( = JOINTS).
■ Cartesian coordinate system ( = CART).
■ Mixed coordinate system ( = MIXED).
■ Auxiliary coordinate system (=AUX).
4
‐
24
Operating the BendMaster 2015-06-01
B579EN
Switching between manual
and automatic mode
Coordinate systems for
displaying the axis positions