Trumpf BendMaster 150, Operator'S Manual

Page: 165 / 258

− Backlighting table : can only be selected if a backlighting
table is available.
For fine recognition with
two fine recognition windows: if
the two fine recognition windows lie outside the previ-
ously entered "position"" or "rotational position", toleran-
ces, a fine recognition is carried out on the backlighting
table.
For fine recognition with
one fine recognition window: No
action is carried out after a faulty fine recognition,
because there is not enough position data available.
− Rough recognition and backlighting table : Combination of
the two strategies. First a rough recognition is carried
out. If the rough recognition fails, then a fine recognition
is carried out on the backlighting table. Can only be
selected if a backlighting table is available.
Strategy by which, after a failed fine recognition in the selected
area, work is to be congtinued with a rough recognition. Can be
defined only for loading areas.
5. Select "Height measurement mode":
− As with job setting (default value): the job is resumed
with the programmed settings.
− No height measurement : no additional rough recognition
is carried out.
Determination of the minimum quantity of sheets in a stack in
the selected area at which an advance warning (message) is
issued.
6. Enter the quantity in the "Advance warning from" field.
Determination as to the number of pieces starting from which a
loading stack in the selected area will be marked "empty" in the
control. Can only be defined for loading areas.
7. Enter the stack height in the "Stack empty code" field.
or
Ø As with job setting (Default value): The job is resumed
with the programmed settings.
Components with extrusions only on one side result in angled
material stacks. With "Board rotation" and "Offset in X", every
part can be deposited rotated and/or offset from the previous
part.
8. Enter "Sheet rotation". Permitted values: 0° or 180°.
Rotation takes place around the center of the defining com-
ponent rectangle.
9. Enter "Offset in X".
B579EN
2015-06-01 Running in a TruTops program
4
‐
71
"Height measurement mode"
"Advance warning from"
"Stack empty code"
"Sheet rotation" and "Offset
in X"