Trumpf BendMaster 150, Operator'S Manual

Page: 135 / 258

Fig. 41441
Note
Reference the D axis (see "Referencing the D axis", pg.
4
‐
41) .
4. Press the blue button on the portable manual control unit for
the axis to be referenced.
5. Press the blue Z3 button on the portable manual control unit.
An automatic reference trip of the regripping station to the
left reference switch at the parking position is started.
6. Press the blue Z4 button on the portable manual control unit.
An automatic reference run of the regripping station to the
right-hand reference switch at the parking position is started.
Referencing the D axis
Conditions
■ Manual operating mode is active.
■ No error messages, i.e. green LED on the portable manual
control unit lights up (acknowledge error if red LED is on).
(see "Enabling conditions for operation modes", pg. 4
‐
17) .
■ The BendMaster is ready for operation (pulse trigger switch
on the portable manual control unit has been pressed,
"BendMaster" icon is green).
1. Select the > Position > Position menu on the portable manual
control unit.
2. Press Reference .
B579EN
2015-06-01 Switching on and referencing the BendMaster
4
‐
41