Tieline Bridge-IT, User Manual

Page: 218 / 227

218 Bridge-IT Manual v4.0
© Tieline Research Pty. Ltd. 2019
18.6 Compliances and Certifications
FCC Compliance Notice
This equipment has been tested and found to comply with the limits for a class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area may cause harmful
interference, in which case the user will be required to correct the interference at his/her own
expense. There is no guarantee, however, that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
·
Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
·
Consult the dealer or an experienced radio or TV technician for help.
CAUTION:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Declaration of Conformity
The Tieline Bridge-IT IP codec meets the requirements of directives for CE and C-Tick
certifications. Technical documentation required by the conformity assessment procedure is kept
at the head office of Tieline Technology; 1/25 Irvine Drive, Malaga, Western Australia 6090.
EN 55 022 Statement
This is to certify that Tieline Bridge-IT is shielded against the generation of radio interference in
accordance with the application of EN 55 022: 2006 Class A. Technical documentation required by
the conformity assessment procedure is kept at the head office of Tieline Technology; 1/25 Irvine
Drive, Malaga, Western Australia 6090.
Canadian Department of Communications Radio Interference Regulations
This digital apparatus (Tieline Bridge-IT) does not exceed the Class A limits for radio-noise
emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Règlement sur le brouillage radioélectrique du ministère des
Communications
Cet appareil numérique (Tieline Bridge-IT) respecte les limites de bruits radioélectriques visant les
appareils numériques de classe A prescrites dans le Règlement sur le brouillage radioelectrique
du ministère des Communications du Canada.
Safety of Electrical and Electronic Products and Components
The IECEE CB Scheme is an international system for mutual acceptance of CB test reports and
certificates covering the safety of electrical and electronic products and components. The IEC CB
is a multilateral scheme among participating countries and certification organizations, based on
the use of international (IEC) standards.