Tieline Bridge-IT, User Manual

Page: 42 / 227

42 Bridge-IT Manual v4.0
© Tieline Research Pty. Ltd. 2019
6. Click to configure your preferred Jitter Buffer setting. Select Auto Adapt and your preferred
automatic jitter setting, or Fixed Level . For a fixed buffer setting enter the Jitter Buffer Depth ,
which has a maximum setting of 5000ms, then press .
Important Notes: Automatic or fixed jitter buffer settings can be adjusted on individual
client codecs as required. There is no jitter buffer setting on the server codec because it
never receives audio packets.
7. Select Data to enable or disable data in the audio stream. See RS232 Data Configuration for
more information on data connections.
8. Select Proto (protocol) to select the audio protocol and adjust the Local Audio Port . Select
UDP/IP +RTP for RFC compliant IP streaming. Press to save settings.
7. If required, enable
A/Recon (auto reconnect) and navigate to Via to specify which IP streaming
interface is used to dial this connection, e.g. Primary (Ethernet port) or VLAN (if configured).
Note: By default Any will select Primary .
8. Press the RETURN button when configuration is complete to navigate backwards to the
Connect IP screen that the multicast IP address was entered into.
Important Note: At this point you can navigate to Save on the Connect IP screen and
press to save the settings as a custom program for subsequent recall and dialing. Use
the numeric KEYPAD to give the program a name and press to save the program. A
confirmation message is displayed after the program is saved.