Tieline Bridge-IT, User Manual

Page: 118 / 227

118 Bridge-IT Manual v4.0
© Tieline Research Pty. Ltd. 2019
2. Click the New Program symbol to open the wizard and then:
· Click in the text box to name the new program.
· Select Multi-unicast , or if you want to use an existing program as a template, select this
option. Then click Next .
Important Note: When you decide to use an existing program as a template, the new
program inherits all the settings of the template program and you can adjust these settings
as required by continuing through the program wizard.
3. To configure new program level rules click the drop-down arrow and select the preferred option
from those available. Click the blue Plus symbol to add a new rule and click the Minus
symbol to remove a rule.
Important Notes for Rules:
· Bridge-IT XTRA has 4 physical CONTROL PORT GPIOs ; 7 Tieline and WheatNet
virtual inputs (1-7); 64 Tieline virtual logic outputs; and, 64 virtual WheatNet logic
outputs (these allow Tieline WheatNet-IP enabled codecs to activate functions across a
WheatNet-IP network).
· Bridge-IT has 2 physical CONTROL PORT GPIOs ; 5 Tieline and WheatNet virtual
inputs (1-5); 64 Tieline virtual logic outputs; and, 64 virtual WheatNet logic outputs
(these allow Tieline WheatNet-IP enabled codecs to activate functions across a
WheatNet-IP network).
· A non-WheatNet-IP Tieline codec can be configured to trigger a WheatNet LIO in a
Tieline WheatNet-IP codec.
· Tieline WheatNet-IP codecs require Wheatstone Razor firmware version 1.4.22 or later
to support WheatNet LIOs. In addition, the WheatNet-IP codec must have the
WNet
Enable LIO checkbox selected in the Options panel of the HTML5 Toolbox Web-GUI.
·
Relay reflection is not available for SIP and Multicast Client programs.
·
Connection-related rules are not displayed in Answer only audio streams.
· Program level rules intended to activate dialing are not valid in Answer only programs or
audio streams.
· For more details about rules see Creating Rules .
4. Enter a name for the
Audio Stream and add a caller ID . Then click Next . Note: The caller ID
is used to identify calls.