Tieline Bridge-IT, User Manual

Page: 103 / 227

103
© Tieline Research Pty. Ltd. 2019
Bridge-IT Manual v4.0
Click the check-box to select Enable Redundant SmartStream PLUS and configure dual
Ethernet SmartStream IP streaming (To learn more visit
http://www.tieline.com/Transports/SmartStream-IP ). Alternatively, click Next to configure
Auto Reconnect or a failover connection, whereby the alternative connection is dialed if the
primary connection fails.
By default, primary IP streaming is via the LAN port. To achieve the maximum level of
redundancy select Secondary to configure redundant streaming from VLAN1 (or select
another Via ). The redundant stream uses Remote Audio Port 9001 by default and the
Local Audio Port allocated is Automatic . Note: Automatic indicates that the codec will
arbitrarily allocate the local port value and send this information to the codec to which you
are dialing.
8. Click Next and select the Enable Auto Reconnect check-box at this point in the wizard to
enable this setting. Then click Next to configure answering settings.
Important Note: When Auto Reconnect is enabled, the dialing codec will continue to
attempt a connection with the remote codec until Disconnect is pressed either on the
dialing codec's keypad, or in the Web-GUI.
Configuring the Codec to Answer Connections
If you are configuring the codec to answer an incoming audio stream connection:
1. Enter a name for the answering connection and click Next .
2. Configure the IP transport settings, including the Session Protocol and Local Audio
Port .