Tieline Bridge-IT, User Manual

Page: 120 / 227

120 Bridge-IT Manual v4.0
© Tieline Research Pty. Ltd. 2019
6. Follow the instructions on the right-hand side of the panel to configure the transport settings for
the connection, then click Next . Note: only the first connection dialed in a multi-unicast
program can encode and decode audio. All other connections are unidirectional and encode
only.
Important Note: See RS232 Data Configuration for detailed information on RS232 data.
Only in-band auxiliary data using the Music or MusicPLUS algorithms is possible when
connecting to G3 Commander and i-Mix codecs.
7. Configure the IP address, ports, and then specify which streaming interface is used to dial this
connection, e.g. Primary ( LAN / ETHERNET port and default setting) or VLAN if configured.
Note: By default Any will select Primary .
Important Notes: The Remote Audio Port is the codec port at the remote end of the link
to which you are sending audio. The Local Audio Port is the port used by the local codec
to receive audio from the remote codec. When Tieline Codecs is the Session Protocol
selected (using Tieline session data), the default port value for the Local Session Port
and Local Audio Port is Automatic . Note: Automatic indicates that the codec will
arbitrarily allocate the local port value and send this information to the codec to which you
are dialing. Click to deselect the
Automatic check-box and change this setting.
Click Save Program to save the program with the default algorithm, jitter and FEC settings which
are physically entered in the codec. Alternatively, click Next to specify individual algorithm, jitter
buffer, FEC and auto reconnect settings for this audio stream (recommended).
8.
Click the drop-down arrows on the right-hand side of each text box to adjust the Encoding
,
Sample rate
or
Bit rate
options.