Tieline Bridge-IT, User Manual

Page: 29 / 227

29
© Tieline Research Pty. Ltd. 2019
Bridge-IT Manual v4.0
13 Getting Connected Quickly
Preparing to Connect
Before attempting a new connection please connect and adjust the following:
1. Attach the supplied 12 volt power supply to the codec.
2. Attach an RJ45 Ethernet cable to the
LAN port on the rear panel of the codec.
3. Attach headphones to the 6.35mm (1/4") headphone jack on the rear panel of the codec.
4. Check that the correct country is selected in the codec.
i. Press the SETTINGS button.
ii. Navigate to System and press the button.
iii. Navigate to Country and press the button.
iv. Use the navigation buttons to select your country of operation.
5. Make sure you have the IP address of the codec you are dialing, or have used the HTML5
Toolbox web-GUI to load the programs you will be using to dial onto the codec. (see
Configuring IP Addresses ).
13.1
Quick Steps to Connect Bridge-IT
Important Notes:
·
The following procedure will create a custom peer-to-peer connection program using
the codec front panel keypad and navigation buttons. It instructs how to connect your
codec over IP for the very first time without using the Toolbox web-GUI and your
computer for configuration.
·
See the HTML5 Toolbox Web-GUI Introduction for details on configuring connections
remotely via a computer.
· See Installing the Codec at the Studio for valuable information about installing your
codec, negotiating firewalls and port forwarding.
· See Tips for Creating Reliable IP Connections for a range of IP information to assist
with setting up IP services for your codecs.
·
See Testing IP Network Connections to learn how you can test and verify the reliability
of your IP connection.
1. Press the button and right navigation button to open the Input Audio Level adjustment
screen and adjust audio levels.
· Press on the numeric KEYPAD to toggle channel 1 on and off and press to toggle
channel 2 on and off.
· Use the up and down navigation buttons to select Gang 1 + 2 and press the
button to toggle ganging on/off.
·
Use the up and down navigation buttons to select a single channel, or ganged
channels. Note: A channel is highlighted when selected.
·
Use the left and right navigation buttons to adjust the input levels up or down.
Important Note: 15 volt phantom power is not supplied to input 1 by default. To adjust
this setting select Settings , then Audio and then Phantom . Press the OK button to
toggle between Disabled and Enabled .
2. Press the HOME button to return to the Home screen, select Connect and press the
button, then select IP and press the button.