Thermo Scientific AQUAfast AQ3700, User Manual

Page: 208 / 264

20 Thermo Scientific Orion AQUAfast AQ3700 Colorimeter User Guide
2.1 Operation
2.1.1 Set up
Before working with the meter insert the batteries (delivery contents). See chapter 2.1.2 Saving
data – Important Notes, 2.1.3 Replacement of batteries.
Before using the meter perform the following settings in the Mode-Menu:
MODE 10: select language
MODE 12: set date and time
MODE 34: perform „Delete data“
MODE 69: perform “User m. init” to initialise the userpolynomial system
See chapter 2.4 Meter settings.
2.1.2 Saving data – Important Notes
The batteries save data (stored results and meter setting).
During battery change the data in the Orion AQ3700 is saved for 2 minutes. If the change
time exceeds 2 minutes all stored data and settings
are lost.
Recommendation: for replacement a screwdriver and new batteries must be available.
2.1.3 Replacement of batteries
See chapter 2.1.2 "Saving data - important notes" before replacing batteries.
1. Switch the instrument off.
2. If necessary remove vial from the sample chamber.
3. Place the instrument upside down on a clean and even surface.
4. Unscrew the four screws (A) of the battery compartment cover (B).
5. Lift off battery compartment cover at the notch (C).
6. Remove old batteries (D).
7. Place 4 new batteries.
Ensuring the correct polarity!
8. Replace the battery compartment cover.
Check the seal ring (E) of the notch to make sure if is tight-fitting
9. Tighten the screws carefully.
CAUTION
Dispose of used batteries in accordance with all federal, state and local regulations.
•
•
•
•