Tektronix Keithley SourceMeter 2470, Reference Manual

Page: 637 / 995

2470 High Voltage SourceMeter Instrument Reference Manual Section 13: Introduction to TSP commands
2470-901-01 Rev. A /
May
2019 13-51
Triggering
The triggering commands allow you to set the conditions that the instrument uses to determine when
measurements are captured.
trigger.blender[N].clear() (on page 14-193)
trigger.blender[N].orenable (on page 14-193)
trigger.blender[N].overrun (on page 14-194)
trigger.blender[N].reset() (on page 14-194)
trigger.blender[N].stimulus[M] (on page 14-195)
trigger.blender[N].wait() (on page 14-197)
trigger.clear() (on page 14-197)
trigger.digin[N].clear() (on page 14-198)
trigger.digin[N].edge (on page 14-199)
trigger.digin[N].overrun (on page 14-200)
trigger.digin[N].wait() (on page 14-200)
trigger.digout[N].assert() (on page 14-201)
trigger.digout[N].logic (on page 14-202)
trigger.digout[N].pulsewidth (on page 14-203)
trigger.digout[N].release() (on page 14-204)
trigger.digout[N].stimulus (on page 14-204)
trigger.lanin[N].clear() (on page 14-206)
trigger.lanin[N].edge (on page 14-206)
trigger.lanin[N].overrun (on page 14-207)
trigger.lanin[N].wait() (on page 14-208)
trigger.lanout[N].assert() (on page 14-208)
trigger.lanout[N].connect() (on page 14-209)
trigger.lanout[N].connected (on page 14-210)
trigger.lanout[N].disconnect() (on page 14-211)
trigger.lanout[N].ipaddress (on page 14-211)
trigger.lanout[N].logic (on page 14-212)
trigger.lanout[N].protocol (on page 14-212)
trigger.lanout[N].stimulus (on page 14-213)
trigger.timer[N].clear() (on page 14-251)
trigger.timer[N].count (on page 14-252)
trigger.timer[N].delay (on page 14-253)
trigger.timer[N].delaylist (on page 14-254)
trigger.timer[N].enable (on page 14-255)
trigger.timer[N].reset() (on page 14-256)
trigger.timer[N].start.fractionalseconds (on page 14-257)
trigger.timer[N].start.generate (on page 14-257)
trigger.timer[N].start.overrun (on page 14-258)
trigger.timer[N].start.seconds (on page 14-259)
trigger.timer[N].start.stimulus (on page 14-259)
trigger.timer[N].wait() (on page 14-261)
trigger.tsplinkin[N].clear() (on page 14-261)
trigger.tsplinkin[N].edge (on page 14-262)
trigger.tsplinkin[N].overrun (on page 14-263)