Suzuki Wagon R Plus RB310, Service Manual

Page: 131 / 846

4A-10 FRONT DRIVE SHAFT (G10/M13 ENGINES)
7) Remove wheel side boot big band (1) as follows.
• For boot big band without joint
Cut boot big band using a iron saw or a nipper with care not
to damage wheel side joint housing.
• For boot big band with joint
Draw hooks of boot big band together and remove band.
8) Remove wheel side small band, then pull out wheel side
boot from shaft.
Assembly
For DOJ type
Judging from abnormality noted before disassembly and what is
found though visual check of each component after disassembly,
prepare replacement parts and start assembly, and make sure
that wheel side joint (1) and differential side joint (2) are washed
thoroughly and air dried, and boots (3) are cleaned with cloth if
they are to be reused.
1) Wash disassembled parts (except boots), and then dry parts
completely by blowing air.
2) Clean boots with cloth.
[A]: For boot big band without joint
[B]: For boot big band with joint
CAUTION:
• Do not wash boots in degrease, such as gasoline or
kerosene, etc. Washing in degrease causes deteriora-
tion of boots.
• To ensure full performance of joint as designed, be
sure to distinguish two types of grease in spare part
and apply the specified amount of grease to each joint.
[A]: For wheel side joint
[B]: For differential side joint
[1]: For left side shaft
[2]: For right side shaft
NOTE:
Do not wash boot in degreaser, such as gasoline or kero-
sene, etc. Washing in degreaser causes deterioration of
boot.