Suzuki Wagon R Plus RB310, Service Manual

Page: 420 / 846

ENGINE MECHANICAL (M13 ENGINE) 6A2-81
5) Loosen main bearing cap No.1 and No.2 bolts in such order
as indicated in figure and remove them.
6) Remove crankshaft from cylinder block.
Installation
1) Install sensor plate (1) to crankshaft (2) and tighten bolts to
specified torque.
Tightening torque
Sensor plate bolt (a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
2) Install main bearings to cylinder block.
Upper half of bearing (1) has an oil groove (2).
Install it to cylinder block (3), and the other half without oil
groove to bearing cap.
Make sure that two halves are painted in the same color.
CAUTION:
• Use new bearing cap No.1 bolts. They are deformed
once they are used because they are plastic deforma-
tion tightening bolts.
• All parts to be installed must be perfectly clean.
• Be sure to oil crankshaft journals, journal bearings,
thrust bearings, crankpins, connecting rod bearings,
pistons, piston rings and cylinder bores.
• Journal bearings, bearings caps, connecting rods, rod
bearings, rod bearing caps, pistons and piston rings
are in combination sets. Do not disturb such combina-
tion and make sure that each part goes back to where
it came from, when installing.
NOTE:
When installing sensor plate, align spring pin (3) on
crankshaft and hole of sensor plate.