Suzuki Wagon R Plus RB310, Service Manual

Page: 109 / 846

3E-18 REAR SUSPENSION
6) Install rear axle shaft to rear axle housing and tighten brake
back plate bolts to specified torque.
Tightening torque
Brake back plate bolt (a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
7) Connect brake pipe to wheel cylinder and tighten brake pipe
flare nut to specified torque.
Tightening torque
Brake pipe flare nut (b): 16 N·m (1.6 kg-m, 11.5 lb-ft)
8) Tighten oil drain plug to specified torque and refill rear axle
(differential) housing with new specified gear oil and tighten
oil filler plug to specified torque. Refer to Section 7F for tight-
ening torque data and refill.
9) Apply watertight sealant where plate and cable contact, and
run parking brake cable (1) through brake back plate (2) and
secure it with clip (3).
“A”: Sealant 99000-31090
10) Connect parking brake cable (1) to parking brake shoe lever.
Install brake shoes referring to “Brake Shoe Installation” in
Section 5C.
11) Install wheel speed sensor (if equipped with ABS).
12) Install brake drum (right & left) after marking sure that inside
of brake drum and brake shoes are free from dirt and oil.
Then tighten brake drum screw.
13) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to “Bleeding Brakes” in Section 5.)
14) Install wheel and tighten wheel bolts to specified torque.
15) Upon completion of all jobs, pull parking brake lever with
about 200 N (20 kg, 44 lbs) load three to five times so as to
obtain proper drum-to-shoe clearance.
Adjust parking brake cable (for adjustment, refer to “Parking
Brake” in Section 5).
16) Check to ensure that brake drum is free from dragging and
proper braking is obtained.
17) Perform brake test (foot brake and parking brake).
(For brake test, see Section 5.)
18) Check each installed part for oil leakage.
NOTE:
When installing rear axle shaft, be careful not to cause
damage to oil seal lip in axle housing.
CAUTION:
Check to ensure that clip is in good condition before
installing it. If deformed or broken, replace.