Suzuki Wagon R Plus RB310, Service Manual

Page: 230 / 846

ENGINE GENERAL INFORMATION AND DIAGNOSIS (M13 ENGINE) 6-2-55
3 MIL Power Supply Check
1) Disconnect ignition switch connector.
2) Remove “METER” fuse.
3) Measure resistance between “BLU/BLK”
wire terminal of ignition switch connector
and “BLU/BLK” wire terminal of “METER”
fuse connector.
Is resistance 1
Ω
or less?
Go to Step 4. “BLU/BLK” wire circuit open or
poor connection.
4 MIL Power Supply Check
1) Connect ignition switch connector.
2) Install “METER” fuse.
3) Remove combination meter referring to
“Combination Meter Removal and Installa-
tion” in Section 8.
4) Check for proper connection to combination
meter connector at “BLK/RED” wire and
“PPL/WHT” wire terminals.
5) If OK, then turn ignition switch to ON posi-
tion and measure voltage between combi-
nation meter connector at “BLK/RED” wire
terminal and body ground.
Is it 10 – 14 V?
Go to Step 5. “BLK/RED” wire circuit open.
5 MIL Circuit Check
1) Turn ignition switch OFF position.
2) Disconnect ECM connector “E21”.
3) Check for proper connection to ECM con-
nector at “E21-1” wire terminal.
4) Measure resistance between “PPL/WHT”
wire terminal of combination meter connec-
tor and “E21-1” wire terminal of ECM con-
nector.
Is resistance 1
Ω
or less?
Go to Step 6. “PPL/WHT” wire circuit open.
6 MIL Circuit Check
1) Connect combination meter connectors.
2) Turn ignition switch to ON position.
3) Using service wire, ground “E21-1” terminal
wire of disconnected ECM connector.
Does MIL turn ON?
Substitute a known-
good ECM and
recheck. Replace bulb.
Step Action Yes No