Suzuki Wagon R Plus RB310, Service Manual

Page: 136 / 846

FRONT DRIVE SHAFT (G10/M13 ENGINES) 4A-15
5) Place new wheel side boot small band (1) onto boot putting
band outer end (2) against forward rotation (3) as shown in
figure.
6) Install wheel side boot small band (1), putting its lower edge
against projected end (4) of boot (3) so that clearance “a” is
provided as shown in figure.
7) Fasten small band by using special tool.
Special tool
(A): 09943-57010
8) Install damper (1) on right side drive shaft according to
dimension specified below, if equipped.
Damper installing position
“a”: 347 – 353 mm (13.66 – 13.90 in.)
9) Set new differential side small band and differential side boot
(1) on shaft temporarily.
Apply grease to tripod joint (2). Use specified grease in tube
included in spare parts.
10) Install tripod joint spider (3) on shaft, facing its chamfered
spline inward (wheel side), then fasten it with snap ring (4).
Special tool
(A): 09900-06107
2. Shaft
3
2
4
1
“a”
NOTE:
• Small band must not come out of its installation sec-
tion.
• Be sure to caulk small band securely until complete
contact “b” is obtained.
(A)
“b”