Suzuki Wagon R Plus RB310, Service Manual

Page: 75 / 846

3B1-4 ELECTRICAL POWER STEERING (EPS) SYSTEM (IF EQUIPPED)
Table-B “EPS” Warning Lamp Remains ON
Step Action Yes No
1 Was “System Check Flow Table” performed? Go to Step 2. Go to “System Check
Flow Table” in this section.
2 1) With ignition switch OFF, disconnect 8 pin
(“A”) connector from P/S control module.
2) Measure resistance between “G14-5” termi-
nal of “A” connector and body ground.
Is resistance 1
Ω
or less?
Go to step 3. Substitute a known-good
P/S control module and
recheck.
3 1) Disconnect “G25” connector from Combina-
tion meter.
2) Turn ignition switch to ON position.
3) Check voltage between “G25-9” and body
ground.
Is it 10 – 14 V?
Replace bulb in combina-
tion meter, and then
recheck. Repair short to ground in
“G14-5” wire circuit.
[A]: Fig. for Step 2