Suzuki Wagon R Plus RB310, Service Manual

Page: 732 / 846

AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-163
Inspection
O/D and 2nd Coast Blake Return Spring Subassembly
Measure free length of O/D and 2nd coast blake return spring.
Free length of O/D and 2nd coast blake return spring
“a”: 18.99 mm (0.748 in.)
Transaxle Rear Cover Bush
7) Measure transaxle rear cover bush bore by using special
tool.
Special tool
(A): 09900-20605
Transaxle rear cover bush bore
Standard: 13.94 – 14.00 mm (0.549 – 0.551 in.)
If measured transaxle rear cover bush bore is out of specifica-
tions, replace transaxle rear cover with new one. In replacement,
intermediate shaft subassembly also needs to be checked.
Replace intermediate shaft subassembly, if necessary.
Assembly
Reverse disassembly procedure for assembly, noting the following
points.
• Use new seal rings and O-rings. Apply A/T fluid to seal rings
and O-rings before installation.
• Tighten rear cover plugs to specified torque.
Tightening torque
Rear cover plug: 7.5 N·m (0.75 kg-m, 5.5 lb-ft)
• Before installing rear cover seal ring, apply A/T fluid to ring.
First, tighten seal ring to 5 mm (0.197 in.), then install seal
ring.
• Do not open rear cover seal ring too wide to attach.
NOTE:
• Do not apply excessive force when measuring spring
free length.
• Perform measurement at several points.
1. Transaxle rear cover