Suzuki Wagon R Plus RB310, Service Manual

Page: 815 / 846

7F-18 REAR DIFFERENTIAL
Tightening Torque Specification
Required Service Material
These contact patterns, located on toe or heel on both
drive and coast sides, mean that 1) both pinion and
gear are defective, 2) carrier is not true and square, or
3) gear is not properly seated on differential case. The
remedy is to replace the defective member.
Irregular patterns: If the pattern is not oval, it means
that bevel gear is defective. High or low spots on tooth
surfaces or on the seat of bevel gear are the cause of
irregular patterns appearing on some teeth. The rem-
edy is to replace the pinion and-gear set and, if the
seat is defective, so is transfer case.
Tooth Contact Pattern Diagnosis and Remedy
Fastening part
Tightening torque
N•m kg-m lb-ft
Rear differential oil drain plug 55 5.5 40.0
Rear differential oil level/filler plug 50 5.0 36.5
Drive bevel pinion nut (reference) 70 – 250 7.0 – 25.0 51.0 – 181.0
Drive bevel gear bolt 80 8.0 58.0
Differential side bearing cap bolt 23 2.3 17.0
Differential carrier bolt 23 2.3 17.0
Propeller shaft bolt 23 2.3 17.0
Material
Recommended SUZUKI product
(Part Number)
Use
Thread lock cement THREAD LOCK CEMENT 1322
(99000-32110) Drive bevel gear bolts
Lithium grease SUZUKI SUPER GREASE A
(99000-25010) Oil seal lips
Sealant SUZUKI BOND NO. 1217G
(99000-31260) • Thread part of differential carrier bolt
• Mating surface of differential carrier
• Mating surface of rear axle housing