Suzuki Wagon R Plus RB310, Service Manual

Page: 753 / 846

7B1-184 AUTOMATIC TRANSAXLE (M13 ENGINE)
15) Install parking lock pawl (1) and spring (2). Apply A/T fluid to
parking lock pawl shaft, then insert it into transaxle case.
16) Install new planetary ring gear subassembly (1) to reduction
drive gear (3) by using special tools and hydraulic press.
Special tool
(A): 09951-18210
(B): 09944-78210
17) Tighten new reduction drive gear nut to planetary ring gear
subassembly little by little until reduction drive gear bearing
preload is within specification.
Tightening torque
Reference: 100 N·m (10.0 kg-m, 72.5 lb-ft)
Reduction drive gear bearing preload (turning torque)
Standard: 0.05 – 0.35 N·m (0.5 – 3.5 kg-cm, 0.036 – 0.253
lb-ft)
CAUTION:
• Do not reuse planetary ring gear subassembly. Other-
wise it may cause damage to planetary gear unit and/or
reduction gears.
• Do not use transaxle case as groundwork to press fit
planetary ring gear subassembly.
• Do not give load more than 20 kN (2,000 kg, 4410 Ib)
with hydraulic press. Otherwise, it may result in dam-
aging reduction drive gear bearing.
2. Stand that can slightly lift transaxle case.
CAUTION:
• Do not tighten nut over the specifications so that
reduction drive gear nut would not be broken.
• Carry out this procedure on rubber mat in order not to
damage transaxle case.