Suzuki Wagon R Plus RB310, Service Manual

Page: 370 / 846

ENGINE MECHANICAL (M13 ENGINE) 6A2-31
14) Disconnect the following electric lead wires:
• TP sensor (1)
• MAP sensor (2)
• ECT sensor (3)
• EGR valve (4)
• CMP sensor (5)
• IAC valve (6)
• Ignition coil assembly (7)
• Injectors (8)
• Heated oxygen sensor (9)
• Oil control valve (10)
• Engine oil pressure switch (11)
• CKP sensor (12)
• Knock sensor (13)
• VSS (14)
• Back up light switch (15)
• Generator (16)
• Starting motor (17)
• Ground terminal (18) from cylinder block
• Battery ground cable (19) from transaxle
• Magnet clutch switch of A/C compressor (if equipped)
• Each wire harness clamps
15) Remove fuse box from its bracket.
16) Disconnect the following cables:
• Accelerator cable (20)
• Gear select control cable (21)
• Gear shift control cable (22)
• Clutch cable (23)
17) Disconnect the following hoses:
• Brake booster hose (24) from intake manifold
• Radiator inlet and outlet hoses (25) from each pipe
• Heater inlet and outlet hoses (26) from each pipe
• Fuel feed hoses (27) from fuel feed pipe
18) Remove exhaust No.1 pipe referring to “Exhaust Manifold
Removal and Installation” in this section.
19) Disconnect right and left drive shaft joints to differential gear
referring to “Removal” in Section 4.
For engine and transaxle removal, it is not necessary to
remove drive shafts from steering knuckle.
20) For 4WD vehicle, remove propeller shaft referring to “On-
Vehicle Service” in Section 4B.
1
26
2
20
3
6
27
4
24
5
25
7
8
13 16 17
14 18 12
19
15 22
23
21
9
11
10