9-18 ELECTRICAL SYSTEM
GEAR POSITION SENSOR
• Lift and support the fuel tank. (
5-3)
• Disconnect the gear position switch coupler
and check the
continuity between Bl and B/W with the transmission in “NEU-
TRAL”.
09900-25008: Multi-circuit tester set
Tester knob indication: Continuity test (
)
• Connect the gear position switch coupler to the wiring har-
ness.
• Turn the ignition switch ON and side-stand to upright position.
• Measure the voltage between P and B/W lead wires using the
multi-circuit tester when shifting the gearshift lever from low to
top.
09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
Tester knob indication: Voltage (
)
Gear position switch voltage: 0.6 V and more
* Low to top gear position (P
– B/W
)
* Except neutral position
(P
– B/W
)
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition
switch, or electronic parts may get damaged.
Use the special tool, to prevent the rubber of the water
proof coupler from damage.
ON (Neutral)
Bl
B/W
OFF (Except neutral)
V
Summary of Contents for GSX-R1000 2007
