Suzuki GSX-R1000 2007, Service Manual

Page: 93 / 549

ENGINE 3-43
CLUTCH SLEEVE HUB/PRIMARY DRIVEN GEAR ASSEMBLY
• Inspect the slot of the clutch sleeve hub and primary driven
gear assembly for damage or wear caused by the clutch
plates. If necessary, replace it with a new one.
CLUTCH LIFTER
CLUTCH LIFTER DRIVE CAM AND DRIVEN CAM INSPEC-
TION
• Inspect the clutch lifter drive cam and driven cam for wear or
damage.
• If any defects are found, replace the clutch lifter drive cam
and driven cam as a set.
CLUTCH LIFTER PIN ADJUSTMENT
NOTE:
When adjusting the clutch lifter, it is not necessary to install the
clutch onto the countershaft.
• Assemble the following parts into the primary driven gear
assembly. ( 3-92 to -96)
* Clutch sleeve hub
* Spring washer seat, Spring washer
* Clutch drive plates, Clutch driven plates
* Pressure plate
* Clutch springs, Clutch springs set bolts
"
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Remove the clutch assembly from the primary driven gear
assembly.