Suzuki GSX-R1000 2007, Service Manual

Page: 123 / 549

ENGINE 3-73
ENGINE REASSEMBLY
• Reassemble the engine in the reverse order of disassembly.
• The following steps require special attention or precautionary
measures should be taken.
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling.
• Be sure to install the following items to the crankcase.
* Crankshaft journal bearing (
3-70)
* Gearshift fork ( 3-58)
* Gearshift fork shaft ( 3-58)
* Gearshift shaft bearing ( 3-57)
* Gearshift cam bearing ( 3-57)
* Gearshift cam ( 3-57)
* Bearing retainer ( 3-58)
* Oil jets ( 3-60)
PISTON RING
• Install the piston rings in the order of oil ring, 2nd ring and 1st
ring.
• The first member to go into the oil ring groove is a spacer .
After placing the spacer, fit the two side rails .
NOTE:
Side designations, top and bottom, are not applied to the spacer
and side rails: you can position each either way.
"
INCORRECT
#
CORRECT
• Install the 2nd ring and the 1st ring to the piston.
NOTE:
1st ring and 2nd ring differ in shape.
When installing the spacer, be careful not to allow its
two ends to overlap in the groove.