Suzuki GSX-R1000 2007, Service Manual

Page: 297 / 549

FUEL SYSTEM AND THROTTLE BODY 5-29
• Repeat the procedures of Step 2.
• Disconnect the vacuum tester and install the removed parts.
• After completing the throttle valve synchronization, clear the
DTC and reset the ISC learned value using SDS tool.
(
4-28 and 5-26)
USE OF MODE SELECT SWITCH
The following procedure discribes only defference between use
of SDS tool and use of mode select switch.
Step 1
• Step 1 is the same as the use of SDS tool.
Step 2
• Connect the special tool (mode select swich) and turn it ON.
• Start the engine and warm it up.
* Summer: Approx. 5 min. at idle speed
* Winter:
Approx. 8 min. at idle speed
NOTE:
* The ISC valve is automatically set at synchronization mode.
* Water temperature should be more than 80 °C (176 °F) and
then wait 30 seconds.
• Other procedures are the same as the Step 2 of using SDS
tool.