Suzuki GSX-R1000 2007, Service Manual

Page: 411 / 549

CHASSIS 8-77
BRAKE PAD REPLACEMENT
• Remove the pad mounting pin .
• Remove the caliper mounting bolt .
• Remove the brake pads with the rear caliper pivoted up.
• Clean up the caliper especially around the caliper piston.
• Install the new brake pads.
"
Pad mounting pin: 16 N·m (1.6 kgf-m, 11.5 lb-ft)
Brake caliper mounting bolt: 18 N·m (1.8 kgf-m, 13.0 lb-ft)
NOTE:
After replacing the brake pads, pump the brake pedal a few
times to set the brake parts correctly and then check the brake
fluid level.
* This brake system is filled with an ethylene glycol-based DOT 4 brake fluid. Do not use mix
different types of fluid such as silicone-based or petroleum-based.
* Do not use any brake fluid taken from old, used or unsealed containers. Never reuse brake
fluid left over from the last servicing or stored for long periods.
* When storing the brake fluid, seal the container completely and keep away from children.
* When replenishing brake fluid, take care not to get dust into fluid.
* When washing brake components, use fresh brake fluid. Never use cleaning solvent.
* A contaminated brake disc or brake pad reduces braking performance. Discard contaminated
pads and clean the disc with high quality brake cleaner or neutral detergent.
Handle brake fluid with care: The fluid reacts chemically with paint, plastics, rubber materials
etc. and will damage then severely.
* Do not operate the brake pedal with the pads
removed.
* Replace the brake pads as a set, otherwise braking
performance will be adversely affected.