4-15
Operating Instructions
Operator Manual
920017-148
1.
Press
STOP/RESET
touch pad once to interrupt cycle operation. Pressing
STOP/RESET
touch pad once interrupts cycle and removes remaining water
and vapor from wash chamber. Display shows:
VAPOR EXHAUST
PLEASE WAIT
... and printer records:
*STOP PRESSED
HH:MM:SSXM
IMPORTANT:
Unit has a built-in 60-second (approximately) delay to prevent
doors from opening before washer is in a safe state. Operator must wait until
the end of the delay before opening doors. Display shows:
CYCLE IS PAUSED
START TO CONTINUE OR
... alternating with:
CYCLE IS PAUSED
PRESS STOP TO ABORT
2.
Press
CYCLE/START
touch pad to resume cycle operation. Treatment
resumes where it was interrupted. Printer records:
*CYCLE RESUME
HH:MM:SSXM
-- or --
Press
STOP/RESET
touch pad to abort cycle (see Section 4.8,
Abort Cycle
Operation).
STOP
RESET
CYCLE
START
4.7 Pause Cycle
Operation
WARNING – BURN HAZARD:
•
After pressing STOP/RE-
SET touch pad, wait until
water flow stops before
opening doors. Hot water/
steam may be sprayed
through door opening if
doors are opened too soon.
•
Except for emergency, do
not open door when cycle
is in progress. In an emer-
gency, first stop cycle by
pressing the EMERGENCY
STOP pushbutton and wait
for water flow to stop. Wear
appropriate Personal Pro-
tective Equipment (PPE)
whenever reaching into or
entering wash chamber.
•
Inner surfaces of washer
are very hot after cycle
completion. Operator
should wear appropriate
personal protective equip-
ment (PPE) and avoid all
contact with inner walls
when entering chamber.
STOP
RESET
