1-2
920017-148
Operator Manual
Safety Precautions and Symbols
WARNING – ELECTRICAL SHOCK AND/OR BURN HAZARD:
Disconnect all utilities to washer before servicing. Do not service washer unless all utilities have been properly
locked out. Always follow local occupational health and safety regulations, as well as electric and plumbing codes.
WARNING – BURN HAZARD:
After pressing STOP/RESET touch pad, wait until water flow stops before opening doors. Hot water/steam may
be sprayed through door opening if doors are opened too soon.
Except for emergency, do not open door when cycle is in progress. In an emergency, first stop cycle by pressing
the EMERGENCY STOP pushbutton and wait for water flow to stop. Wear appropriate Personal Protective
Equipment (PPE) whenever reaching into or entering wash chamber.
Inner surfaces of washer are very hot after cycle completion. Operator should wear appropriate Personal Protective
Equipment (PPE) and avoid all contact with inner walls when entering chamber to unload washer.
WARNING – SLIPPING HAZARD:
To avoid slippery floor conditions, immediately wipe up any spilled liquids or condensation.
WARNING – CHEMICAL BURN AND/OR EYE INJURY HAZARD:
Always use non-foaming chemical for effective cleaning and proper pump and water level control operation. Follow
manufacturer's recommendations for amount of chemical to be used.
Detergents are caustic and can cause adverse effects to exposed tissues. Do not get in eyes, on skin or attempt
to swallow.
• Read and follow the precautions and instructions on the detergent label and in the Material Safety Data Sheet
(MSDS) prior to handling detergent containers, or servicing the detergent injection pumps and lines.
• Wear appropriate Personal Protective Equipment (PPE) whenever handling chemicals or servicing chemical
injection pumps and lines.
Wear appropriate Personal Protective Equipment (PPE) when using a descaling product. Avoid contact with eyes
or skin. If spilled or splashed, flush with water for 15 minutes. If swallowed, DO NOT induce vomiting. Administer
an alkali with plenty of water. Seek medical attention immediately.
CAUTION – POSSIBLE EQUIPMENT DAMAGE:
Always leave plenty of space between load and doors. Leaning load against doors will damage doors and also
prevent them from opening or closing.
Always use a silicone lubricant to lubricate squeeze tubes. Petroleum-based lubricants, such as Vaseline or
grease, will cause squeeze tubes to melt.
Avoid product damage. Always select a cycle appropriate for the items being processed.
Before operating the unit, always position manifolded Bottle Washing Cart and/or Central Header Manifold over
central water inlet connector. If manifolded accessory is not positioned correctly, damage may result and unit will
be unable to effectively wash load.
(See next page for additional Safety Precautions)
