4-1
Operating Instructions
Operator Manual
920017-148
IMPORTANT:
A listing of the
Safety Precautions to be observed when operating
and servicing this equipment can be found in Section 1 of this manual. Do not
operate or service the equipment until you have become familiar with this
information.
1.
Verify building electrical supply disconnect switch (circuit breaker) is
positioned to
ON
. Verify unit supply valves are open.
2.
Verify EMERGENCY STOP pushbuttons are pulled out on Load and Unload
sides of washer.
3.
Verify wash chamber is empty and all material has been removed.
4.
Verify debris screen in bottom of sump is clean and properly installed.
5.
Open printer door and verify sufficient amount of printer paper is available.
NOTE: A colored warning stripe is visible when paper roll is near the end. See
Section 6.6, Printer Paper Roll Replacement, if paper roll needs to be replaced.
6.
Put POWER-OFF/STANDBY switch to POWER position. Display shows:
*
STERIS
*
*
BASIL 9502
*
... and printer records:
* CONTROL ON
HH:MM:SSX
YY/MM/DD
*********************************
***** BASIL 9502 **********
**** S/N 3600000000 ****
*********************************
7.
Side tanks fill with water (if not already full). Display screen automatically
advances to the first Cycle Menu of factory-set cycles. Display shows:
RODENTS
BOTTLES
RABBITS
PRIMATES
___indicates flashing position.
4.1 Before
Operating Washer
OPERATING INSTRUCTIONS
4
Current Time
Current Date
Unit Serial
Number
