Steris Basil 9502, Operator'S Manual

Page: 34 / 94

4-10
920017-148 Operator Manual Operating Instructions
STOP
RESET
CYCLE
START
CYCLE
MENU
SELECT
CYCLE
CYCLE
START
DOOR
CLOSE
The Basil ® 9502 Cage and Rack Washer is pre-programmed at factory with four
processing cycles and two maintenance cycles, and is capable of retaining up
to six additional cycles (see
Table 5-1 ). Each cycle can be customized to
include up to seven different treatments. For instructions on programming, refer
to Section 5,
Cycle and Control Value Programming.
The following cycle description is based on the pre-programmed PRIMATES
cycle. See
Table 4-1 for default treatment values of the PRIMATES cycle.
NOTE: Note the following regarding the typical cycle:
1) Washer operation can be interrupted at any time by pressing STOP/RESET
touch pad. To resume cycle, press CYCLE/START touch pad. To abort cycle,
press STOP/RESET touch pad a second time.
2) After washer operation has been interrupted, a 60-second delay will prevent
doors from opening before it is safe to do so. Operator must wait until the end
of the delay before opening doors.
3) If unit fails or if any abnormal condition occurs during a cycle, see Section 7,
Troubleshooting, to identify the possible cause and corrective action.
1. Once washer is properly loaded, press DOOR CLOSE touch pad to close
doors. The first Factory-set Cycle Menu appears on the screen. Display
shows:
RODENTS BOTTLES
RABBITS PRIMATES
___ indicates flashing position
NOTE: To access one of the other two cycle menus, press CYCLE MENU touch
pad.
2. Press SELECT CYCLE touch pad to select PRIMATES cycle from the
displayed menu.
3. When desired cycle is selected (cycle name is flashing on display screen),
press
CYCLE/START touch pad. The name of the selected cycle appears
on the screen and remains displayed during the safety delay. Display
shows:
PRIMATES STARTING
PRIMING
... then:
PRIMATES STARTING
MM:SS
4.5 Typical Cycle
Operation
Name of
Cycle Started
CAUTION – POSSIBLE
EQUIPMENT DAMAGE:
Avoid product damage. Al-
ways select a cycle appro-
priate for the items being
processed.
Safety Delay
Countdown