205
Oelmaier
56 Oelmaier
56.1 Oelmaier
Termination
Addressing
Interface
Yes
Yes
RS485
Overview
•
Integrated interface
•
Where to connect: Terminal strip behind service cover
•
2-pin wiring
•
Communication address must be allocated
•
Installation steps
•
Switch off the inverters and Solar-Log™
•
Connect inverters to the Solar-Log™
•
Connect the inverters to each other
•
Allocate communication address
Connect inverters to the Solar-Log™
The wiring is done using a
•
self-made, shielded 2 wire data cable with a terminal block connector.
Procedure
1. Open the inverter as shown in the inverter's instructions.
2. If you are making the cable yourself, connect the wires as shown in the following diagram:
Solar-Log™ terminal strip connector
Terminal strip inside the inverter
Terminal
Terminal
►
1
►
A-Data +
►
4
►
B-Data -
3. Terminate the inverter as shown in the inverter's instructions.
4. Close inverters.
5. Insert the terminal block connector into the Solar-Log™ RS485 socket.
Connect the inverters to each other
•
Where to connect: Terminal strip behind service cover
•
2-pin wiring
Summary of Contents for Solar-Log
