Siemens SITRANS FUH1010PVDX, Operating Instructions Manual, Page: 44 / 308

2-6
CQO:1010PVXFM-3
Section 2
2.6 INSTALLATION MENU OPERATION WITH THE MAGNETIC WAND
This section describes how to use the Magnetic Wand to access the Installation Menu. It will show you
how to navigate through its hierarchical structure and how to enter/edit site parameters. (Note that many
of these menu selections may be made prior to permanently installing the meter in the field.) Refer to
paragraph 2.2 Power Connections and Engineering Drawing 1010PVX-7 (or 1010PVXD-7) for wiring
instructions before turning on unit.
2.6.1 ACCESSING AND LEAVING THE INSTALLATION MENU
When you first apply power to the meter, there will be a 20 to 30 second delay and then you will see a
scrolling banner and a copyright notice appear on the LCD panel display. This means that the meter
requires a new (or stored) site setup to be loaded into its
active memory (active memory will be
explained later). The first time you access the Installation Menu, you can leave it only by saving a site or
by turning the meter off. After installing and activating a site, use the ENTER sensor to toggle between the
local flow display screen and the last accessed menu location.
TYPICAL MENU SCREEN AS IT APPEARS IN A COMMUNICATION PROGRAM
Siemens
To access the Installation Menu:
z
Make sure the Menu Lockout Switch is in the unlocked position (see paragraph 2.3).
z
Momentarily place the Magnetic Wand tip over the [ENTER] switch (located above the target sym-
bol). This accesses the top level of the Installation Menu, as shown in the following figure. Note that
the top line of the LCD display shows the currently selected menu [Meter Type] and that the second
line shows [Single Channel] preceded by the “greater than” symbol (>).
Siemens
1010PVX
Copyright 2008
LCD panel display showing
initial screen with copyright
notice.