Siemens SITRANS FUH1010PVDX, Operating Instructions Manual, Page: 189 / 308

6-5
CQO:1010PVXFM-3
Section 6
6.3 THE APPLICATION INFO MENU
This menu provides a live display of the basic timing data used by the meter during operation.
To activate AnCal:
Move the cursor to the [AnCal] menu cell by pressing . Press the to enable
numeric entry. Note that an equal sign (=) appears before the number.
Enter the desired flow rate using current rate units (e.g., 120.00 GPM). Note that the
[Flow] menu cell now reflects the artificial rate.
Move the cursor away from the menu cell by pressing to turn [AnCal] off.
Flow GAL/MIN 120.00
Total GAL 5645.820
Vs m/s 1274.33
Signal mV 44
Valc % 57
Vaer % 13
Alarm Status ------M--
AnCal GAL/MIN > 120.000
HiFlow GAL/MIN 1577.9
LoFlow GAL/MIN -1577.9
Siemens Dual Path SITE1
Flow Rate Simulation Control
Flow Data
The M status is
asserted due to the
method used to
simulate flow data.
Note that the [Flow]
menu cell immediately
reflects the AnCal entry.
Over time, the Total
display will also
increase.
TN uSec 75.193
TL uSec 44.009
DeltaT 126
Burst/Sec 256
Last Makeup (Re)Start
Makeup Status Measurement
Siemens Dual Path SITE1
Time between transit and receive
Application Info
APPLICATION INFO MENU ITEMS
TN uSec The total elapsed time between the transmission and reception of a sonic pulse.
TL uSec The total time a sonic pulse takes to travel through the liquid.
DeltaT nSec This is the instantaneous result of subtracting the down from the up transit
times.
NOTE: This will appear to be more active than dampened flow readings .
Burst/Sec Number of transmissions per second under current operating conditions. The
following factors influence this parameter: aeration, pressure transients, signal
strength variation.
Last Makeup Reason for last Makeup (signal reacquisition). Press the meter’s [Help] key at
this menu cell to see a glossary of all the possible reasons for a Makeup.
Makeup Status Current stage of Makeup routine. [Measurement = normal operation]