Siemens SITRANS FUH1010PVDX, Operating Instructions Manual, Page: 202 / 308

6-18
CQO:1010PVXFM-3 Section 6
To Mount Transducers on a 996PSP Pipe Simulator:
z
Using coupling compound, mount the transducers on the pipe simulator as shown on the previous
page. Slide each transducer until it presses against a pin-stop. Use the clamps to hold the transducer
in place.
z
Connect cables between each transducer and the computer connectors for the channel under test.
The Up and Down orientation is not important.
z
Access the Installation Menu. Select [Meter Type] [Single, Dual] depending on meter type. Select the
meter path/channel (1 or 2) depending on which measurement channel you intend to test. Select
[Clamp-On] and then [Channel Setup].
z
Access [Channel/Path Setup] menu. Move highlight to [Create/Name Site]. Create a new Site Setup
(e.g., TEST1). You can now enter data without altering an existing Site Setup.
z
Select the [Pipe Data] Menu. Referencing either the English or metric pipe simulator chart below,
enter the pipe parameters corresponding to the transducer size under test.
Clamping Screw
Xdcr
Clamping
Bracket
991 Transducers
Under test
Pipe Simulator
Transducer
Pinstops
Part Xdcr Pipe Pipe Wall Mount Letter Number
Number Size OD (in) Mat’l Thk (in) Mode Index Index*
996PSP PIPE SIMULATOR CHART (English)
996PSP-0 0 2.420 PVC 0.076 Direct A 6
996PSP-1 1 2.481 PVC 0.077 Direct A 9
996PSP-2 2 2.743 PVC 0.136 Direct A 6
996PSP-3 3 3.758 PVC 0.344 Direct A 1
996PSP-4 4 6.500 PVC 1.000 Direct** A 0
* The computer generates the Number Index. ** See note below.
Part Xdcr Pipe Pipe Wall Mount Letter Number
Number Size OD (mm) Mat’ Thk (mm) Mode Index Index*
996PSP-0 0 61.47 PVC 1.93 Direct A 6
996PSP-1 1 63.02 PVC 1.96 Direct A 9
996PSP-2 2 69.67 PVC 3.45 Direct A 6
996PSP-3 3 95.45 PVC 8.74 Direct A 1
996PSP-4 4 165.1 PVC 5.4 Direct** A 0
996PSP PIPE SIMULATOR CHART (Metric)
* The computer generates the Number Index. ** See note below.